Furuno FAR-2167DS-D Fabricating the power cable TYPCY-2.5, How to fabricate power cable TYPCY-2.5

13.In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto the HV cable.

14.As shown in the figure below, fold back the armor onto the flat washer and insert it thru the other flat washer. Cut off the part of the armor that protrudes past the washer.

Flat washer

(1) (2) (3)

HV cable

Gland nut	Cut off armor that
	protrudes past washer.
	Gasket

15.Pass the HV cable through its cable gland and tighten gland nut.

16.Using the terminal opener, connect wiring to TB901, referring to the interconnection diagram.

CAUTION

High voltage is present at the No. 6 pin of TB901. Miswiring at this pin can damage the antenna unit.

17.Close the cover.

18.Seal the cable gland for the HV cable with putty.

Fabricating the power cable TYPCY-2.5

1.Use a ratchet or box wrench to open the port-side cover on the antenna unit.

2.Unfasten the gland nut for the power cable and remove gasket, flat washer (3 pcs.) and gland cap. (The gland cap may be discarded.)

3.Fabricate the power cable as shown below. Unravel the armor. Wrap sheath with vinyl tape to fix base of vinyl wire.

Armor

25 mm	Sheath
	5 mm
	Sheath

		FV2-4	Conductor
			S = 2.50 mm2
	230 mm
			φ = 2.01 mm
Vinyl sheath Armor
			SECTIONAL VIEW

How to fabricate power cable TYPCY-2.5

2-5