Furuno FAR-2167DS-D, FAR-2167DS-BB installation manual Assembling the antenna unit

Assembling the antenna unit

The antenna unit should be assembled before mounting it. Follow the procedure below to assemble the antenna unit.

1.Screw the guide pins (2 pcs.) in the radiator.

2.Remove the protective cap from the choke guide and radiator.

3.Grease the O-ring and set it to the groove on the choke guide.

4.Place the radiator on the radiator bracket. (Radiator direction is shown by the logo on the bracket. If reversely oriented the radiator cannot be set to the bracket.)

5.Loosely fix the radiator to the radiator bracket with hex bolts (M10×25), spring washers and flat washers.

6.Remove the guide pins and tighten the hex bolts.

Spring washer, flat washer,

10 pcs. each, M10x25

Protective cap Radiator bracket

Choke guide

O-ring

Antenna radiator

Do not remove teflon tube from the center conductor.

Radiator front

Guide pin (2 pcs.)

Arrow mark for the radiator front.

CAUTION

Be sure to remove the guide pins after fixing the radiator.

Injury may result if the guide pins loosen and fall from antenna radar platform.

Assembling the antenna unit

1-3