Furuno FAR-2167DS-BB, FAR-2167DS-D Processor unit, side view, Processor unit bottom chassis

1. Remove the top cover and open the upper part of the processor unit.

DVI-D port

(Connect DVI cable at step 12.)

Processor unit, side view

2.Fix the RGB-BUFF board (03P9229B board) with four screws. (See the figure below.)

3.Attach the connector assemblies to J1 and J3 on the 03P9229B board as follows.

J1: 13-pin connector of the connector assembly 03-2094

J3: 3-pin connector of the connector assembly 03-2093

4.Attach six sets of spring washers and spacers at the locations shown below.

Spring washer, spacer	03P9229B board
		(Connect RGB Cable at step 10.)
	J2

J1 J3 J2

03P9342 board

J615 (Connect connector assembies at step 8.)

Processor unit (bottom chassis)

4-14