Furuno FE-700 Turning On/Off Tone and Brilliance, Panel Dimmer, ROM OK Dram OK Sram OK Battery OK

1.3 Turning On/Off 1.4 Tone and Brilliance

1.Turning on: Press the POWER Switch. Self-test starts, showing the condition of the logic circuits. The program number is displayed.

ROM: OK

DRAM: OK

SRAM: OK

BATTERY: OK

PROGRAM NO. 0252297002

2.Select a mode with the MODE Selector. The NAV position of the selector is recommended for general use. Display color is amber by default but may be customized. The unit of measurement is meters. You can freely select another mode at any time.

3.Turning off: Press the POWER Switch again.

Wait at least 5 s before reapplying the power.

Note: When two transducers are installed, make sure which transducer is used.

Note: When lat/long data input error occurs, “EPFS” ERROR appears on the screen. (EPFS: Electronic Position-Fixing System such as GPS receiver)

1.Press the BRILL key. The tone and brilliance setting window appears.

	LOW ▼	▲ HIGH
BRILL:	8 „ „ „ „ „ „ „ „
	LOW -	+ HIGH
TONE:	3 „ „ „ † † † † † †

2.Press the [+] or [-] key for desired tone (in reality, Contrast).

3.Press the [▲] or [▼] key for desired brilliance. Pressing the BRILL key also changes the brilliance from minimum to maximum and vice-versa.

Note: Tone or brilliance must be adjusted within 10 seconds after pressing the BRILL key. Otherwise the tone and brilliance window will be erased.

1.5 Panel Dimmer

1.Press the DIM key. The panel dimmer setting window appears.

LOW - + HIGH

DIMMER: 5 „ „ „ „ „

2.Press the [+] or [-] key for desired illumination of the control panel. Pressing DIM key also changes the illumination level.

3