4. BASIC SETUP
To set reason for unable
If you have chosen UNABLE as the COMPLY STATUS, set the reason as follows:
1.Rotate the CH knob (or press up / down arrow key) to choose UNABLE REASON from the AUTO ACK MENU and press the ENT key. The following menu appears.
NO REASON
BUSY
EQUIP DISBLD
MODE UNAVAIL
CH UNAVAIL
2.Rotate the CH knob (or press up / down arrow key) to choose a reason for
UNABLE.
3.Press the ENT key.
Note: This menu is the same as manual acknowledgement. EQUIPMENT DISABLE is shown in calls when EQUIP DISBLD is selected.
To set position call response
1.Rotate the CH knob (or press up / down arrow key) to choose the POSITION CALL from the AUTO ACK MENU and press the ENT key.
2.Rotate the CH knob (or press up / down arrow key) to choose ON or OFF as
appropriate.
OFF: Disables automatic acknowledgement of position request.
ON: Enables automatic acknowledgement of position request.
3. Press the ENT key.
To set polling call response
1.Rotate the CH knob (or press up / down arrow key) to choose the POLLING CALL from the AUTO ACK MENU and press the ENT key.
2.Rotate the CH knob (or press up / down arrow key) to choose ON or OFF as
appropriate.
OFF: Disables automatic acknowledgement of polling request.
ON: Enables automatic acknowledgement of polling request.
3. Press the ENT key.
