|
| – Screw together the air guidance housing and |
|
| screw it onto the two retaining brackets (Fig. 25). |
|
| – Establish the pipe connection between the air |
|
| connection piece and the air guidance housing. |
|
| – Establish the electrical connection. |
|
| – Stick the included sealing strips (8 strips) around |
|
| the air slots on the top chimney paneling. |
Fig. 25 |
| – Remove the protective foil from the chimney |
| paneling. | |
|
| |
|
| Note: Avoid damaging the sensitive stainless steel |
|
| surfaces. |
|
| – Join the chimney shoe with the chimney base |
|
| using the 6 screws (3.5 x 9.5 mm) (Fig. 26). |
|
| – Fit the top of the chimney into the base. Make |
|
| sure that the fastening holes on the side are at the |
|
| top. |
|
| – Secure the top duct unit with 2 screws on the |
|
| ceiling holder. |
|
| – Pull the shoe down into its final position |
|
| (Fig. 27) |
Fig. 26 |
| Note: Avoid scratches when fitting the elements |
| into one another by placing the assembly template, | |
|
| |
|
| for example, over the edge of the bottom chimney |
|
| paneling to protect it. |
|
| – Make sure that an activated charcoal filter is |
|
| installed (see page 10). |
|
| – Reinsert the grease filters. |
|
| – Again screw in the two black plates on the left |
|
| and right of the chimney. |
|
| – Place the glass plates on the black plates. |
Fig. 27 |
|
|
03.6028.63 | 12.99 SK | 17 |
