GarrettCom 1008 Magnum 1000 Workgroup Hubs, Installation and User Guide 04/02, Warranty, RPM Type

Magnum 1000 Workgroup Hubs Installation and User Guide (04/02)

Power Supply (Internal)

AC Power Connector: IEC-type, male recessed, rear of chassis

Input Voltage: 90 to 260 VAC (auto-ranging)

Input Frequency: 47 to 63 Hz (auto-ranging)

Power Consumption: 10 watts typical, 20 watts max. P.S. rating

(For 48VDC power input option, see Appendix B).

Agency Approvals

UL Listed (UL 1950), cUL, CE

Emissions meet FCC Part 15 Class A

Warranty
Three years, return to factory	Made in USA

1.2Specifications - Repeater Port Modules (RPMs)

RPM Type :	BNC	AUI	DTE	Fiber-mm Fiber-sgl.m		TP*
Front Access	yes	yes	yes	yes	yes	yes
Connector Type	BNC-f	DB-15 f	DB-15 m	Fiber-ST Fiber-ST		RJ-45
Partition (PART)LED	yes	yes	yes	yes	yes	yes
Receive (RX) LED	yes	yes	yes	yes	yes	yes
LINK LED	n.a.	n.a.	n.a.	yes	yes	yes
Switch on Face Plate	yes**	n.a.	n.a.	n.a.	n.a.

yes***

“Fiber-mm” is multi-mode cable, normally used for 10BASE-FL installations, up to 2.0Km.

“Fiber-sgl.m” is single-mode cable, used for distant installations, up to 10.0Km.

*The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded and shielded twisted pair wiring.

**Internal termination switch for BNC, no "T" connector is required.

***MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link, no crossover cable is required.

1.3Specifications - Bridge Port Modules (BPMs)

BPM Type :	BNC	AUI	Fiber	TP*
Connector Type	BNC(f)	DB-15(f)	ST	RJ-45
Switch on FP	yes**	n.a.	n.a.	yes***
FWD-I LED	yes	yes	yes	yes
FWD-X LED	yes	yes	yes	yes
LINK LED	n.a.	n.a.	yes	yes

*The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded and shielded twisted pair wiring.

**Internal termination switch for BNC, no "T" connector is required.

***MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 up-link, no crossover cable is required.

www . GarrettCom . com

2