7Place the old drive in an antistatic bag or container, then place the new hard drive on a static-free surface with the top up and the connectors facing you.

8Install two small, plastic drive mounting rails (L rail on the left and R rail on the right) to the new hard drive. Make sure the front rail extensions are towards the connector end of the device. Align the wire retention clips to the mounting holes in the drive and press the rails to the sides of the drive.

L rail

R rail

R

L

9Set the drive jumpers to the appropriate settings (refer to your drive documentation for jumper settings).

10Align the rails with an open bay in the bottom drive cage, and slide the drive into the cage until the locking tabs snap into place. Be sure that the data and power connectors on the drive face out.

11Connect the power and data cables to the drive.

12Close the case by following the instructions on page 20.

13Reconnect peripherals, the modem cord, and the power cord, then turn on the system.

Adding a hard drive

The system comes equipped with a drive cage that will accept additional hard drives. You may have to purchase an additional data cable with three connectors and of sufficient length to connect the existing hard drive and the new drive to the appropriate drive controller connector (IDE or SCSI) on the system board.

34Replacing and Adding System Components