Replacing or adding memory

The Synchronous Dynamic Random Access Memory (SDRAM) Dual Inline Memory Modules (DIMMs) supported by your system board conform to the following standards:

■64 MB, 128 MB, 256 MB, and 512 MB DIMMs.

■PC133-compliant, registered, parity, ECC SDRAM.

Memory is installed in four banks (slots) on the system board. When you are selecting and installing DIMMs, keep the following in mind:

■Registered DIMMs should not be combined with unbuffered DIMMs.

■No jumper settings are required for the memory size or type because the BIOS automatically detects this information.

■2 GB maximum system memory.

To replace DIMMs:

1Turn off the system and disconnect the power cord, modem cord (if installed), and all external peripheral devices.

2Remove the left side cover panel. (See “Removing the side cover” on page 18 and “Preventing static electricity discharge” on page 15.)

3Pull open the socket latches on each side of the DIMM socket, then lift the DIMM out of the socket. Store the DIMM in an antistatic container.

Replacing or adding memory

37