Replacing Convertible Notebook Components

18Lay the black bracket on the fingerprint reader, then replace the two screws removed in Step 14.

19Make sure the brown fingerprint reader cable connector clip is in the raised position, then insert the cable into the connector and lower the clip onto the cable.

Important

The cable is correctly oriented if it is not twisted.

20Press the two halves of the LCD panel front and back together in several places until they click in place. You should find no loose spots or spots where the two halves do not meet.

21Replace the eight LCD panel assembly screws removed in Step 11.

22Replace the eight rubber inserts removed in Step 10.

23Replace the LCD assembly by following the steps in “Replacing the LCD assembly” on page 51.

24Replace the system board by following the steps in “Replacing the system board” on page 35.

25Replace the palm rest by following the steps in “Replacing the palm rest” on page 25.

26Replace the hinge cover by following the steps in “Replacing the hinge cover” on page 23.

27Replace the hard drive by following the steps in “Replacing the hard drive” on page 17.

28Replace the DVD drive by following the steps in “Replacing the DVD drive” on page 14.

29Reconnect the antenna wires to the wireless card by following the steps in “Replacing the IEEE 802.11 wireless card” on page 10.

30Replace the memory bay cover by following the steps in “Adding or replacing memory modules” on page 6.

58