
www.gateway.com
4Replace the screw (2) to hold the rear top cover in place.
5Reconnect the power cord(s) and all other cables.
Installing and removing drives
Your server’s basic configuration includes one optical drive and as many as four SATA or SAS
As you prepare to install drives, remember:
•You must install the optional diskette drive in the left converted hard drive bay.
•Before you install a drive, see the drive’s documentation for information on configuring the drive, setting drive jumpers, and attaching cables.
•You may need to configure the drives you install using the BIOS Setup utility. Press F2 at startup to open the BIOS Setup utility.
Removing and installing an optical drive To remove and install an optical drive:
Caution
The optical drive is not
1Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.
2Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3Follow the instructions in “Opening the server case” on page 29.
4Disconnect the
31