CHAPTER 4: Installing Components

3Pull the drive carrier straight out of the server.

4If you are replacing a hard drive, remove the four screws from the bottom of the drive tray that secure the old hard drive to the tray, then remove the drive from the tray.

5Using the four screws you removed, install the new hard drive into the drive tray.

6Make sure that the tray’s release lever is open, then slide the new drive fully into the empty hot-swap drive bay.

7Push the lever back into place until it latches.

8Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Installing an optional diskette drive

The optional diskette drive kit includes a slimline diskette drive, a 3.5" mounting adapter bracket, 4 screws, and a thumbscrew. The 3.5" adapter bracket fits in the left most 3.5" hard drive bay. There is a thumbscrew to secure the bracket to the chassis. Installation of the optional diskette drive uses one of the hard drive bays, so your server can only hold as many as three hard drives after the installation.

To install an optional diskette drive:

Caution

The diskette drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged.

1Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

2Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

3Follow the instructions in “Opening the server case” on page 29.

4Remove the hard drive from the left-hand hard drive bay by following the instructions in “Removing and installing a hard drive” on page 33.

5Insert the diskette drive into the mounting adapter and secure it with the four screws provided in the kit.

34