CHAPTER 4: Installing Components

5Loosen the thumbscrew (1) holding the retaining clip (2) against the side of the optical drive, then move the retaining clip away from the drive.

Important

The hard drive carriers shown in these illustrations may look different than the actual hard drive carriers in your server.

6Push the optical drive to the right to release the drive from the drive bay, then pull the drive out of the bay.

7Unscrew the two screws holding the optical drive interface board on the back of the optical drive, then remove it.

8Using the two screws you just removed, attach the optical drive interface board to the back of the new optical drive.

32