Installation Steps
ADAC Ultra2 S466 provides extensive customization options. If you need only basic ADAC Ultra2 S466 features and your computer does not use other adapter cards with resource settings that may conflict with ADAC Ultra2 S466 settings, even custom installation can be quick and easy.
Step | Action | Additional Information |
1 | Unpack the ADAC Ultra2 S466 controller | If damaged, call your |
| and inspect for damage. Make sure all | Gateway OEM support |
| items are in the package. | representative. |
2Turn the computer off and remove the cover.
3Make sure the motherboard jumper settings are correct.
4 | Install cache memory on the ADAC Ultra2 | 4 MB minimum cache |
| S466 card. | memory is required. |
5 | Check the jumper settings on the ADAC | See page 57 for the ADAC |
| Ultra2 S466 controller. | Ultra2 S466 jumper |
|
| settings. |
6Set SCSI termination.
7Install the ADAC Ultra2 S466 card.
8Connect the SCSI cables to SCSI devices.
9Set the target IDs for the SCSI devices.
10 Replace the computer cover and turn the power on.
11Run ADAC BIOS Setup.
12Install software drivers for the desired operating systems.
Be sure the SCSI devices are powered up before or at the same time as the host computer.
Optional.
Each step is described in detail below.
Cont’d
54ADAC Ultra2 S466 Hardware Guide