DOS ASPI Driver Error Messages

Message

Gateway Inc. ASPI Manager has NOT been loaded.

Controller setup FAILED error code=[0xab]

No non-disk devices were located

’ERROR: VDS support is *INACTIVE* for logical drives

Corrective Action

The ASPI manager is not loaded. One of the failure codes listed below is displayed next.

Correct the condition that caused the failure. The failure codes are:

0x40 No ADAC adapters found

0x80 Timed out waiting for interrupt to be posted

0x81 Timed out waiting for Response command.

0x82 Invalid command completion count.

0x83 Invalid completion status received.

0x84 Invalid command ID received.

0x85 No adapters found or no PCI BIOS support.

0x90 Unknown Setup completion error

The driver did not find any non-hard drive devices during scanning. A SCSI device that is not a hard disk drive, such as a tape drive or CD-ROM drive, must be attached to this SCSI channel. The SCSI ID must be unique for each adapter and cannot be SCSI ID 0. The supported SCSI IDs are 1, 2, 3, 4, 5, and 6.

The /h option is appended to driver in

CONFIG.SYS or this driver is used with a BIOS that is earlier than v1.10, or no logical drives are configured.

78ADAC Ultra2 S466 Hardware Guide