Step 10 Power Up

Replace the computer cover and reconnect the AC power cords. Turn power on to the host computer. Set up the power supplies so that the SCSI devices are powered up at the same time as or before the host computer. If the computer is powered up before a SCSI device, the device might not be recognized.

During boot, the ADAC Ultra2 S466 BIOS message appears:

ADAC Ultra2 S466 Disk Array Adapter BIOS Version x.xx date Firmware Initializing... [ Scanning SCSI Device ...(etc.)... ]

The firmware takes several seconds to initialize. During this time the adapter will scan the SCSI channel. When ready, the following appears:

Host Adapter-1 Firmware Version x.xx DRAM Size 4 MB 0 Logical Drives found on the Host Adapter

0 Logical Drives handled by BIOS

Press <Ctrl><M> to run ADAC Ultra2 S466 BIOS Configuration Utility

The <Ctrl> <M> utility prompt times out after several seconds. The ADAC Ultra2 S466 host adapter (controller) number, firmware version, and cache DRAM size are displayed in the second portion of the BIOS message. The numbering of the controllers follows the PCI slot scanning order used by the host motherboard.

Chapter 6 Hardware Installation

69