Step 1 Unpack

Unpack and install the hardware in a static-free environment. The ADAC Ultra2 S466 controller card is packed inside an anti-static bag between two sponge sheets. Remove the controller card and inspect it for damage. If the card appears damaged, or if any item listed below is missing, contact your OEM support representative. The ADAC Ultra2 S466 Controller is also shipped with:

∙the ADAC Ultra2 S466 Configuration Software Guide,

∙the ADAC Ultra2 S466 Operating System Drivers Guide,

∙the ADAC Ultra2 S466 Hardware Guide,

∙the software license agreement,

∙the ADAC Ultra2 S466 Configuration Utilities diskette for DOS, and

∙the warranty registration card.

Step 2 Power Down

Turn off the computer and remove the cover. Make sure the computer is turned off and disconnected from any networks before installing the controller card.

Step 3 Configure Motherboard

Make sure the motherboard is configured correctly for ADAC Ultra2 S466. ADAC Ultra2 S466 is essentially a SCSI Controller. Each ADAC Ultra2 S466 card you install will require an available PCI IRQ; make sure an IRQ is available for each controller you install.

Chapter 6 Hardware Installation

55