640t – Installation and Operating Instructions
Power | Power Cord and Foot Switch |
Fig. 5-11. Power Panel.
A.On/Off Power Switch
The On/Off Power Switch is located at the back of the machine. Press the “I” on the switch to turn it on. The LCD will illuminate. The off position, marked “0”, turns the machine off.
B.Circuit Breaker
The Circuit Breaker will trip if there is too much load. Wait for 1 minute after the Circuit Breaker trips and press the switch to reset. If the machine fails to reset, see “Troubleshooting” on page
C.Nomenclature Plate
Technical information is provided on the
Nomenclature Plate:
•Serial Number
•Voltage
•Amps
•Watts
•Hertz
Fig. 5-12. Power Cord and Foot Switch.
A.Power Cord
The Power cord is a 220 VAC, NEMA
B.Foot Switch
The Foot Switch allows the operator to start and stop the laminator while handling the item to be laminated.
Press the Foot Switch to run the laminator. Release it to stop the laminator.
When the Foot Switch is used and the Safety Sensor is blocked, the speed of the laminator drops to 3 fpm (0.9 mpm).
When the Feed Table is removed, the rollers will rotate if the Foot Switch is pressed. The machine will run at 3 fpm (0.9 mpm)
Page
