640t – Installation and Operating Instructions
4.Installation
This chapter describes how to install the machine. There are no operator serviceable parts to the machine other than periodic cleaning. Refer to “7. Operator Maintenance” on page
WARNING: Do not attempt to service or repair the laminator. Failure to observe this warning could result in severe personal injury or death.
Disconnect the plug from the receptacle and contact your dealer or distributor when one or more of the following has occurred.
•The power supply cord or attachment plug is damaged.
•Liquid has been spilled into the laminator.
•The laminator is malfunctioning after being mishandled.
•The laminator does not operate as described in these instructions.
Prior to Installation
Inspect the package for damage. Shipping damage should be brought to the immediate attention of the delivering carrier.
Installation
To set up the laminator for the first time:
1.Place the laminator on a stable flat surface capable of supporting the weight of the machine. An additional work surface near the laminator is recommended for items to be laminated.
2.The laminator should be located so that when not using the rear rewind, exiting film drops freely to the floor or to a table that is lower than the exit point of the laminator. Accumulation of laminate immediately behind the laminator as it exits the equipment may cause the film to wrap around the rollers, jamming the machine.
3.Avoid locating the laminator near sources of heat or cold. The laminator should not be in the direct path of forced heated or cooled air.
4.Connect the attachment plug provided with the laminator to a suitably grounded outlet only.
Page
