GBC 640T General Operation, To run the laminator, Press RUN or the foot switch

640t – Installation and Operating Instructions

6.Operation

This chapter describes how to use the laminator to:

•Operate the machine

•Load films (web the machine)

•Laminate items

•Mount items

General Operation

These instructions assume that the films have been loaded. For information about loading films, see “Loading Film” on page 6-2.

To run the laminator:

1.Turn the laminator On (I) with the power switch located at the back of the machine.

The Display (“Fig. 6-1. Control Panel.”) is:

•Set at COLD or 32*

•Speed 9

•Ready to run

2.Set the Roller Pressure Handle for High Lamination (“Fig. 6-2 Roller Pressure Handle.”).

WARNING: Make sure the print clamp and feed tray are in their proper positions. Your fingers and hands could be trapped and crushed in the rollers. Clothing, jewelry, and long hair could be caught in the rollers and pull you into them.

	Fig. 6-2 Roller Pressure Handle.
3.	Set the Roller Pressure Handle for the thickness
	of the item that is to be laminated or mounted.
4.	Set the desired speed on the control panel.
5.	Press RUN or the foot switch.
	The rollers will begin to turn.
6.	Position the item or items to be laminated or
	mounted on the feed table.
7.	Push the item(s) squarely into the roller nip point
	(where the two rollers meet).
Fig. 6-1. Control Panel.	Additional items can be laminated or mounted
	without stopping and starting the machine.
8.	Release the foot switch or press STOP to
	stop the laminator when all of the items have
	completely exited the rear of the machine.

Page 6-1