640t – Installation and Operating Instructions
10.After the board has cleared the rollers, release the foot switch or press STOP.
Mounting
Tips For Threading Pressure Sensitive Adhesive (PSA) Film
•Use Kraft paper for
•Refer to “Fig.
•Whenever possible, pull the remaining web of film out the front of the laminator after the finished item has been removed.
Pre-Coating Boards
You may wish to
PSA mounting film |
Board |
Fig. 6-16. Laminator Ready for Pre-Coating Boards.
To pre-coat boards:
1.Load the laminator as shown in “Fig.
2.Adjust the roller pressure handle to the proper mounting setting.
3.Start a leader board into the rollers.
4.Press RUN or the foot switch.
5.Continue feeding one board after another. Tip: Butt the leading edge of the next board to the trailing edge of the previous one to ensure an even application of film.
6.Press STOP when the last board exits the machine.
Mounting Only
This process requires a decaled item with PSA mounting adhesive. Refer to the To run the second pass instructions in the Decaling In Two Passes section of this chapter. An alternative method is to use a PSA
Roll-to-Roll
Load and thread the film and media as described in “Loading Film Onto the Supply Shafts” and “Threading Film with a Threading Card”. After you have finished step 14, attach the web to the rear rewind tube with masking tape.
Release liner
PSA overlam
Rear rewind
Adhesive back media
Fig. 6-17. Laminator Ready for Roll-to-Roll.
Page
