Bypass screw | CONVERSION TO PROPANE GAS |
|
|
2.ADJUSTMENTS OF THE TOP BURNER LOW FLAME SETTINGS
Only the low settings for the open top burners can be adjusted by means of the following
procedure: |
| a | a | a |
1. Pull off all the control knobs (1). | 1 |
|
|
|
|
|
|
| |
|
|
|
|
|
2. Open oven door and remove the 5 fixing screws (3 | 2 |
|
|
|
screws "a" and 2 screws "b") underneath the control | b |
|
| |
panel (2). Pull the control panel forward. Taking |
| b | ||
|
|
| ||
|
|
|
| |
care not to damage it, by protecting it with cloth for |
|
|
|
|
example, rest it on the open oven door. |
|
|
|
|
3.To convert the control valves unscrew the control valve bypass screw (3).
3
4. Using a pair of long nose pliers carefully remove the bypass screw.
Save the bypass screws removed from the appliance for possible future
5.Install the correct replacement Bypass screw. See table page 40 for correct size. Tighten the screw down.
6.Replace the control panel and secure with fixing screws. Place back control knobs and proceed with testing.
Caution: Make sure that there is a sufficient gap between the knobs and the front panel, since it is necessary to fully depress the knob before rotating it when igniting the burners.
If you have lifted the maintop, carefully lower it onto the range. The burners are protected against the burner flame going out by Flame safety devices (FSD’s). Take care when lowering the maintop to locate the FSD sensor probes (arrowed below) in their holes in the cook top and the burner bases.
42 | Installation and User Guide CornuFé 1908 - 36" - USA / Can |
