INSTALLATION – WALL MOUNT (optional)
1.Reverse the Handset Hook
Firmly slide the HANDSET HOOK out of the CRADLE. Rotate it 180° and slide it back into the CRADLE.
2.Remove the Base Plate
For wall mount installations, press in the two tabs and pull the BASE PLATE from the back of the telephone.
Note: For future reference, please copy your three digit security code located on the bottom of the unit.
3.Connect the Power Cord
Insert the right angle plug of the POWER CORD into the POWER JACK on the back of the telephone. Let the POWER CORD run down the center of the telephone back.
Note: Do not plug POWER SUPPLY into wall outlet until all other steps are completed.
4.Connect the Short Telephone Line Cord Plug either end of the SHORT TELEPHONE LINE CORD into the PHONE LINE JACK on the back of the telephone.
5.Install the Base Plate so that the Arrows Face Upward
Position the POWER CORD and the SHORT TELEPHONE LINE CORD to run through the top notch in the BASE PLATE. Feed the SHORT TELEPHONE LINE CORD through the large opening in the back of the BASE PLATE. Snap the BASE PLATE into the lower set of tab openings in the base of the telephone, making sure the POWER CORD runs through the bottom notch in the BASE PLATE.
•C. Installation for Wall
•Mount Use
• |
|
|
• | ANSWERPHONE |
|
VOICE TIME/DAY STAMP |
| |
• |
|
|
• |
|
|
• | MEMO MESSAGE RESET PLAY•STOP | ANSWER ON/OFF |
• |
|
|
• |
|
|
• |
|
|
• |
|
|
• |
|
|
• |
|
|
• |
|
|
• |
|
|
• |
|
|
•PRESS
•IN TABS
• |
|
• |
|
• |
|
• | POWER VDC |
• | E LINE |
| |
• |
|
• |
|
• |
|
• |
|
• |
|
• |
|
• | THIS END UP |
• | FOR WALL MOUNT |
| |
• |
|
• |
|
• |
|
• |
|
• |
|
• |
|
• |
|
12
