Copyright 2003 by GE Industrial Systems | GE 225, 300 specification

g

GE

Model:	SG Series 225 and 300 kVA / Series 0
Date of issue:	11/05/2003
File name:	OPM_SGS_ISG_M22_M30_0US_V011
Revision:	1.1
Author:
Identification No.:

Up-dating
Revision	Concern	Date
1.1	“3-wire kit” for RPA Parallel System	11/05/2003

COPYRIGHT © 2003 by GE Industrial Systems

All rights reserved.

The information contained in this publication is intended solely for the purposes indicated.

The present publication and any other documentation supplied with the UPS system is not to be reproduced, either in part or in its entirety, without the prior written consent of GE Industrial

Systems.

The illustrations and plans describing the equipment are intended as general reference only and are not necessarily complete in every detail.

The content of this publication may be subject to modification without prior notice.

OPM_SGS_ISG_M22_M30_0US_V011.doc

2/38

Installation Guide SG Series 225 & 300 kVA

Image 2

GE 225, 300 manual Copyright 2003 by GE Industrial Systems

Contents

SG Series Copyright 2003 by GE Industrial Systems Systems Dear Customer Start UP and Commissioning Preface Table of contents General InstallationBattery Storage Safety instructions when working with battery Risk of electric shock PE Earth GND Ground Safety symbols and warningsSafety warnings Protective Grounding Terminal Layout Layout SG Series 225 and 300 KVA Transport Forklift Crane Dimensions and weightWeight SG Series 225 and 300 kVA Transport UPS only in upright position Storage of the UPS Storage of BatteryDelivery Check -26A of the NEC code for specific requirements Place of InstallationPositioning of the UPS SG Series Openings for input and output cable connections Fixing of the UPS cabinet on the floor Battery location 1-5 RPA system disposition Ventilation and Cooling CFM Packing material recycling Take care not to damage the UPS when moving by forkliftUnpacking Common input Rectifier & Bypass Electrical WiringSeparate input Rectifier & Bypass recommended Input/output over current protection and wire sizing Neutral current could be greater than the phase currents Wire positive and negative plus Ground Phase, 3 wire plus GroundPhase, 4 wire plus Ground See .7.1-1 Copper Wiring Connection Wire Size Range 1-1 Access to the input / output connections Output Load Power connection with common input utilityCommon Input Rectifier / Bypass Cable section for this connection shall be not less then AWG L2-1 Rectifier Phase B L2-2 Power connection separate input utilityL1-1 Rectifier Phase a L1-2 L3-1 Rectifier Phase C L3-2 BR1 Positive pole of the Battery Battery connectionBattery Do not insert the Battery Fuses before the commissioning Setup for SG Series when functioning as frequency converter Manual Bypass, serious damage to the Load could result Power Wiring of Parallel Units 1 RPA Parallel System UPS Parallel Control BUS Connection Terminal units Intermediate units Control bus cables connection Access to the control bus connectionControl BUS Cable Location Interface IM0048 going to P13 Control bus cables routing 11-3 Control Bus cable routing and connection Customer Interface Customer Interface Output potential free contacts 15, 16 Or J2 17, 18 NO, C, NC General Alarm18, 19 Or J2 20, 21 NO, C, NC Acoustic Alarm Or J2 / 1, 2 NO, C, NC Utility Failure GND EPO Emergency Power Off Input contact JP3 38/38