GE 49-85179, JGB428 Operating Instructions, Care, and Cleaning Installation Instructions, Safety

GEAppliances.com

Safety

Clean your cooktop after each spill. Use CERAMA BRYTE® Ceramic Cooktop Cleaner.

only use CERAMA BRYTE® Ceramic Cooktop Cleaner on the glass cooktop. Other creams may not be as effective.

To maintain and protect the surface of your glass cooktop, follow these steps:

Before using the cooktop for the

first time, clean it with CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps protect the top and makes clean-up easier.

Daily use of CERAMA BRYTE® Ceramic Cooktop Cleaner will help keep the cooktop looking new.

Remove the burner grates.

Shake the cleaning cream well. Apply a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner directly to the cooktop.

Use a paper towel or CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops to clean the entire cooktop surface.

Use a dry cloth or paper towel to remove all cleaning residue.

No need to rinse. Be sure no excess residue is left on the electrodes or burner parts.

NOTE: It is very important that you DO NOT heat the cooktop until it has been cleaned thoroughly.

Instructions

Operating Instructions

Care

Use a CeRaMa BRYTe® Cleaning Pad for Ceramic Cooktops or a Scotch-Brite®Multi-Purpose No Scratch blue scrub pad.

Burned-On Residue

WARNING: DaMage to your glass surface may occur if you use scrub pads other than those recommended.

Allow the cooktop to cool.

Remove the burner grates. Spread

a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner to the entire burned residue area.

Using the included CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops, rub the residue area, applying pressure as needed.

If any residue remains, repeat the steps listed above as needed.

For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner and a paper towel.

and Cleaning Installation Instructions

The CeRaMa BRYTe® Ceramic Cooktop Scraper and all recommended supplies are available through our Parts Center. See instructions under “To Order Parts” section on next page.

NOTE: Do not use a dull or nicked blade.

Heavy, Burned-On Residue

Allow the cooktop to cool. Remove the burner grates.

Use a single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue.

After scraping with the razor scraper, spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner to the entire burned residue area. Use the CERAMA BRYTE® Cleaning Pad to remove any remaining residue.

For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner and a paper towel.

TipsTroubleshooting Consumer Support

27