GE JGB428 Safety, Tips, Operating Instructions, Installation, Troubleshooting, Oven Bottom

Models: JGB428 JGB428SERSS 49-85179

1 52
Download 52 pages 46.41 Kb
Page 29
Image 29
Lift-Off Oven Door

GEAppliances.com

Safety

Lift the door straight up and off the hinges.

The gasket is designed with a gap at the bottom to allow for proper air circulation.

Do not rub or clean the door gasket— it has an extremely low resistance to abrasion.

If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

Lift-Off Oven Door

The oven door is removable, but it is heavy. You may need help removing and replacing the door.

To remove the door, open it a few inches to the special stop position that will hold the door open. Grasp firmly on each side and lift the door straight up and off the hinges.

NOTE: Be careful not to place hands between the hinge and the oven door frame since the hinge could snap back and pinch fingers.

To replace the door, make sure the hinges are in the special stop position. Position the slots in the bottom of the door squarely over the hinges. Then lower the door slowly and evenly over both hinges at the same time. If the hinges snap back against

the oven frame, pull them back out.

To clean the inside of the door:

nDo not allow excess water to run into any holes or slots in the door .

nBecause the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand. Any soap left on the liner causes additional stains when the oven is heated.

nThe area outside the gasket can be cleaned with a soap-filled scouring pad.

To clean the outside of the door:

nUse soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door.

nSpillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When the surface is cool, clean and rinse.

nDo not use oven cleaners, cleansing powders or harsh abrasives on the outside of the door.

Instructions

 

Operating Instructions

 

Care and Cleaning

 

Oven Bottom

The oven bottom has a porcelain-enamel finish. To make cleaning easier, protect

the oven bottom from excessive spillovers by placing a cookie sheet on the rack below the rack you are cooking on. This is particularly important when baking a fruit pie or other foods with a high acid content. Hot fruit fillings or other foods that are highly acidic (such as tomatoes, sauerkraut, and sauces with vinegar or lemon juice) may cause pitting and damage to the porcelain-enamel surface and should be wiped up immediately after oven cools.

To clean up spillovers, use soap and water, an abrasive cleaner or soap-filled scouring pad. Rinse well to remove any soap before self-cleaning.

Instructions

Installation

 

 

Tips

Troubleshooting

Oven Air Vents

Never block the vents (air openings) of the range. They provide the air inlet and outlet that are necessary for the range to operate properly with correct combustion.

Vent appearance and location vary.

Air openings are located at the rear of the cooktop, at the top and bottom of the oven door, and at the bottom of the range, under the warming drawer, storage drawer or kick panel (depending on the model).

29

Page 29
Image 29
GE JGB428 Safety, Tips, Operating Instructions, Installation, Troubleshooting, Care and Cleaning, Lift-OffOven Door