Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips
| Ventilation Control | Open | Closed | |
position | |||
| position | ||
|
|
NOTE: Two shipping screwsmust be removed from the vent door before use. See the Installation Instructions in the back of this manual. If you do not plan to use the ventilation feature, leavethese two screws in place.
The ventilation control lever is locatedat the middleleft side of the Zoneline unit, behind the room cabinet.
When set at the closed position, only the air insidethe room is circulated and filtered.
When set at the open position, some outdoor | Vent control |
| |
air will be drawn into the room. This will reduce |
| ||
(shown in | Remove two | ||
the heating or cooling efficiency. | |||
middle position) | |||
shipping screws | |||
|
| ||
Energy Tip: Keep the vent control in the closed |
| (if operation is | |
position. The room air will be filtered and circulated. |
| desired) | |
|
|
Additional controls are located behind the room cabinet.
To remove: Pull out at the bottom to release it from | To replace: Place the tabs over the top rail (1). Push |
the tabs (1). Then lift up (2). | inward at the bottom until it snaps into place (2). |
Consumer Support
To change the air direction, remove the room cabinet. Remove the 7 louver screwsthat hold the louver insert in place. Flip the louver insert 180°, replace the screws and the room cabinet.
Louver screws
4 | Louver screws |
Remove the room cabinet and flip the louver
insert to change the air direction.
Default position