CARE AND CLEANING
(continued)
Lift-Off Oven Door
The oven door is removable, but it is heavy. You may need help removing and replacing the door. Do not lift the door by the handle. This can cause the glass to break or can cause damage to the door.
To remove the door, open it a few inches to the special stop position that will hold the door open. Grasp firmly on each side
●Do not rub or clean the door
NOTE: The gasket is designed with a gap at the bottom to allow for proper air circulation.
and lift the door straight up and off the hinges.
NOTE: Be careful not to place hands between the hinge and the oven door frame as the hinge could snap back and pinch fingers.
To replace the door, make sure the hinges are in the special stop position. Position the slots in the bottom of the door squarely over the hinges. Then lower the door slowly and evenly over both hinges at the same time. If the hinges snap back against the oven frame,
“’’-’’’’’’’’’’’’’’’’’’’4’’’’’”%’/nil I
Outside of the door:
Inside Gasket
pull them back out.
TO CLEAN THE DOOR:
Inside of the door:
●Because the area inside the gasket is cleaned during the self clean cycle, you do not need to clean this by hand. Any soap left on the liner causes additional stains when the oven is heated.
. The area outside the gasket can be cleaned with a scouring pad.
. Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door.
. Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When the surface is cool, clean and rinse.
c Do not use oven cleaners, cleansing powders or harsh abrasives on the outside of the door.
Oven Light Replacement (on some models)
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a
To remove:
1.Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder.
Lift off the cover. | Wire cove;holder |
DO NOT REMOVE ANY SCREWS TO REMOVE COVER.
2.Do not touch hot bulb with a wet cloth. Replace bulb with a
To replace cover:
1.Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover.
2.Connect electrical power to the range.
28
—