GE JEM31L manual Questions?, Use This Problem Solver, ‘==s

	-“–%’-	Questions?
‘==s
+		Use This Problem Solver
	PROBLEM				POSSIBLE CAUSE AND REMEDY
	OVEN WILL NOT				● A fuse in your home may be blown or the circuit breaker tripped. Replace fuse
	COME ON				or reset circuit breaker.
					● Unp]ug your microwave oven, then plug it back in.
					● Make sure 3-prong plug on oven is fully inserted into wal I receptacle.
	CONTROL PANEL				● Door not securely closed.
	LIGHTED, YET				● START must be touched after entering cooking selection.
	OVEN WILL NOT				● Another selection entered already in oven and CLEAWOFF pad not touched
	START
					to cancel it.
					● Make sure you have entered cooking time after touching TIME COOK I & II
					pad.
					● CLEAR/OFF pad was touched accidentally. Reset cooking program and touch
					START pad.
					● Make sure you have entered a temperature after touching TEMP COOK &
					HOLD pad.
					G Make sure you entered a code number after touching AUTO COOK or
					AUTO ROAST.
	FOODS ARE EITHER				● Cooking times may vary because of starting food temperature, food density or
	OVERCOOKED OR				amount of foods in oven. Touch TIME COOK I & 11 pad and additional cooking
	UNDERCOOKED				time for completion.
					● Incorrect power level entered. Check cookbook for recommended power level.
					● Dish was not rotated, turned or stirred. Some dishes require specific
					instructions. Check cookbook or recipe for instructions.
					● Too many dishes in oven at same time. Cooking time must be increased when
					cooking more than one food item. Check cookbook time recommendations,
					● Dish not completely covered as directed during Auto Cook.
					● Previous microwaving left humidity or moisture in oven, thus lessening the
				cooking time in Auto Cook function.
					● Certain vegetables need a standing time after using Auto Cook. Check
					Automatic Cooking Guide.
					● Probe not inserted properly into meat or dish when using Temp Cook & Hold
				or Auto Roast functions. Check cookbook for specific instructions.
	“PRObE” APPEARS ON				● Probe has been forgotten or not seated properly in oven wall when using Temp
	DISPLAY			Cook & Hold or Auto Roast functions.
	“Error”	APPEARS			● During Auto Cook, Auto Reheat or Popcorn program, the door was opened
	ON DISPLAY				before steam could be detected. or steam was not detected in maximum time.
				● No steam was detected by sensor within four minutes and 10 seconds after start
				of Popcorn program.
			All these things are normal with your microwave oven:

●Steam or vtipor escaping from around the door

●Light retlec[ion around door or

OLltel” CLISC

●Dimming oven I ight and change in blower sound may occur while operating at power levels other than high.

●Dul I thumping sound while oven is operating,

●Some TV-Radio interference might be noticed while using your microwave oven. It’s similar to the interference caused by other small appl ianccs and does not indica[e a problem with your oven.

If you need more help... call, toll free: GE Answer Center / 800.626.2000”/ consumer information service

34