GE JGBP38GES, JGBP35GEP mSTALLATION ~STRUCTIONS, Tools Required, Prepare Range For Conversion

mSTALLATION ~STRUCTIONS

HOW TO CONVERT THE RANGE FOR USE WITH 1P GM OR NATURAL GAS

TOOLS REQUIRED:

T-10 Torxdriver (for sealed burners) 1/2” and 3/4” open-end wrench Flat blade screwdriver (small)

Nut drivers or wrenches: 7mm or 5/16” (depending on the size of the spuds)

❑PREPARE RANGE FOR CONVERSION

(1) Turn off gas supply at tie wall.

(2) Turn off the electicd power to the range.

If range has not yet been connected to gas supply, or if flexible connection was made, range maybe pulled out from the wall to make conversion easier.

❑CONVERT THE PRESSURE REGULATOR

WM~G: Do not remove the pressure regulator from the range.

1.For models equipped with sealed burners, remove the storage drawer, broiler drawer or kick panel and locate the pressure regulator at rear of the range.

Remove Screws

Access Cover

On some models, you may have to remove an access cover also.

For models equipped with dual burners, remove the cooktop and locate the pressure regulator at right rear of range.

2.Follow the directions in❑A or Bn that match your regulator type.

Is the e in a ation.

If it is this regulator:

1.Use a coin to remove the cap from the pressure regulator.

2.Turn the cap over and hook it into the slots. The type of gas to be used should now be visible on the top of the cap.

Note: On some models the shut-off valve

Emay be in a different location.

If it is this regulator:

1.Unscrew the plastic-protected hex-nut cap from the regulator.

2.Carefully pry the protective plastic cap off the threaded metal cap. Gently pull the plastic washer off the threads on the other side of the metal cap.

3.Push the plastic cap onto the end of the metal cap displaying the type of gas you are converting to. Press the attached plastic washer onto the threads on the other side of the metal cap.

4.Screw the hex-nut cap back into the regulator. Do not overtighten.

44