ge.com
Safety
Use a sewing needle or
Burner Caps and Heads
Burner caps
Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove
Burner heads
For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire
The slits in the burner heads must be kept clean at all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.
Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.
You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.
To remove
NOTE: Do not use steel wool or scouring powders to clean the burners.
After cleaning
Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.
Replacement
Replace the burner heads and caps. Make sure that the heads and caps are replaced in the correct location. There is one oval (center) head and cap assembly and four side heads and caps.
For model JGBS80:
Medium burner |
|
|
|
|
|
|
|
| Oval head and cap | Small burner | ||||||||||||||||||
head and cap |
|
|
|
|
|
|
|
| head and cap | |||||||||||||||||||
|
|
|
|
|
|
|
|
|
| assembly |
|
| ||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| |||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Large burner | Front of range |
|
Extra large | ||
head and cap | burner head | |
| and cap | |
For model JGBS09:
Medium burner | Oval head and cap | Medium burner | |||
head and cap | head and cap | ||||
|
| assembly |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Front of range |
|
|
|
| ||
Medium burner | Medium |
| burner |
head and cap | head and cap | ||
Instructions Operating Instructions Installation Instructions Troubleshooting
Make sure the slot in the burner head is positioned over the electrode.
Slot
Slot
Electrode 
Make sure that the heads and caps are replaced in the correct locations.
21
Tips Consumer Support
