GE JGSP31GER manual OVEN CONTROL CLOCK Am TMER, Clock, To Set the Timer, To Reset the Timer

OVEN CONTROL CLOCK Am TMER

Clock To Set the Clock

The clock must be set for the automat ic oven timing functions to work properly. The time of day ctinnot be changed during u Timed Bake or CLEAN cycle.

Step 2: Press the INCREASE or DECREASE pad to set the time of day.

Step 3: Press the CLOCK pad to start.

Timer

To Set the Timer

The timer is a minute timer only. The timer does not control oven operations. The mtiximum setting on the timer is 9 hours tind

55 minutes.

1T I M E R

Step 1: Press the TIMER pad.

The timer will sttirt automtitically within a few seconds of releasing the pad.

The timer, as you are setting it, wil I display seconds until 60 seconds is reached.

Step 2: Press the INCREASE or DECREASE pad to set the amount of time on timer.

Then it will display minutes and seconds until 60 minutes is reached.

After 60 minutes, it will display hours (“HR” now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached.

To Reset the Timer

If “TIMER” is showing, press the INCREASE or DECREASE pad until desired time is reached.

If “TIMER” is nt)t showing, press the TIMER pud first, then follow instructions tibovc to set the timer.

To Cancel the Timer

Press the TIMER p~d until the word “TINIER” quits tlashing on the displtiy (Jbout 4 seconds).

Power Outage?

After a power outage, when power is restored, the display will tlash and time shown will no longer be correct-for example, after a

5-minute power interruption the clock will be 5 minutes slow.

The displav. flashes until the clock is reset.- All other functions that were in operation when the power went out will have to be programmed again.

Display Messages

If “DOOr” appears on the display, the door is open. Close the door. [f .’LOCK” appears on the display. the oven door is in the locked position. BAKE, BROIL and COOK TIME c~nnol be set if the door is in the locked position.

End of Cycle Tone

The end of cycle tone is a series of three beeps followed by one beep every six seconds. If YOU WOUl~ like to remove the signal that beeps every six seconds, press and hold the CLEAR/OFF pad for 10 seconds.

To return the signal that beeps every six seconds, press and hold the CLEAR/OFF pad for I () seconds.

9