Installation Instructions
A2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and
a cutout large enough for the exhaust adaptor.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the TOP CABINET TEMPLATE.
CAUTION:Wear safety goggles when drilling holes in the cabinet bottom.
A3 ATTACH EXHAUST DAMPER
Blower plate mounting screw (3 screws)
Blower unit | Blower plate |
Back plate
Blower unit mounting screw (2 screws)
•Place the microwave oven in its upright position, with the top of the unit facing up.
•This microwave oven is shipped assembled for top exhaust.
•Attach the exhaust adapter to the blower plate by sliding it into the guide.
•You will need to make adjustments to ensure proper alignment with your house exhaust duct after the microwave oven is installed.
A4 MOUNT THE MICROWAVE OVEN
CAUTION:To avoid the risk of personal injury (back injury or other injuries due to excessive weight of the microwave oven) or property damage, you will need two people to install this microwave oven.
IMPORTANT: Do not grip or use handle during installation.
WARNING:Risk of Electric Shock. Can cause injury or death: If installing unit with metal countertops, cover the edge of the power supply cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws.
NOTE: When mounting |
|
| |
the microwave oven, |
|
| |
thread power cord through |
|
| |
hole in bottom of top |
|
| |
cabinet. Keep it tight |
|
| |
throughout Steps | 1 | Lift microwave oven, | |
not pinch cord or lift oven | |||
| tilt it forward, and hook | ||
by pulling cord. |
| ||
| slots at back bottom | ||
|
| ||
|
| edge onto four lower | |
|
| tabs of mounting plate. |
2 Rotate front of oven up against cabinet bottom.
3Insert a
13