GE JVM2052 C5 INSTALLING THE CHARCOAL, FILTER

Installation Instructions

1Remove 2 screws on the top front of the grille using a Phillips screwdriver.

2Open the door.

3Remove the grille, pulling it straight off.

Charcoal

Filter

Install the charcoal filter. When properly installed, the wire mesh of the filter should be visible from the front.

Replace the grille and the screws.

Close the door.

Insert mesh-side up

Contents

Note to Installer – Note to Consumer – CONTENTS Page OUTSIDE TOP EXHAUST (EXAMPLE ONLY) OUTSIDE BACK EXHAUST (EXAMPLE ONLY) Exhaust connection: Maximum duct length: Elbows, transitions, wall and roof caps, etc HARDWARE PACKET ADDITIONAL PARTS Page AREMOVING THE MICROWAVE OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE B FINDING THE WALL STUDS C DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET D ALIGNING THE WALL PLATE (Choose A, B or C) OUTSIDE TOP EXHAUST OUTSIDE BACK EXHAUST (VERTICAL DUCT) (HORIZONTAL DUCT) (Vertical Duct) INSTALLATION OVERVIEW A1 ATTACH THE MOUNTING PLATE TO THE WALL A2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET A3 ATTACH EXHAUST DAMPER A4 MOUNT THE MICROWAVE OVEN A4 MOUNT THE MICROWAVE OVEN (cont.) (Horizontal Duct) B1 PREPARE THE REAR WALL FOR OUTSIDE BACK EXHAUST B2 ATTACH THE MOUNTING PLATE TO THE WALL B3 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET B4 ADAPT MICROWAVE OVEN BLOWER FOR OUTSIDE BACK EXHAUST B4 ADAPT MICROWAVE OVEN BLOWER FOR OUTSIDE BACK EXHAUST (cont.) B5 MOUNT THE MICROWAVE OVEN C1 ATTACH THE MOUNTING PLATE TO THE WALL C2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET C3 ADAPT MICROWAVE OVEN BLOWER FOR RECIRCULATION C4 MOUNT THE MICROWAVE OVEN C5 INSTALLING THE CHARCOAL FILTER