Installation Instructions

CRECIRCULATING (Non-Vented Ductless)

INSTALLATION OVERVIEW

C1. Attach Mounting Plate to Wall

C2. Prepare Top Cabinet

C3. Adjust Blower

C4. Mount the Microwave Oven

C5. Install Charcoal Filter

C1 ATTACH THE MOUNTING PLATE TO THE WALL

Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud.

1Remove the toggle wings from the bolts.

2Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the toggle wings to 34onto each bolt.

To use toggle bolts:

 

 

 

 

 

 

 

Spacing for Toggles

 

 

 

 

 

 

 

More Than Wall

 

 

 

 

 

 

 

Thickness

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Mounting

 

 

 

 

Toggle Wings

 

 

 

 

 

 

Toggle

Plate

 

 

 

 

 

 

Bolt

Wall

Bolt End

3Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.

NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch

the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet.

CAUTION:Be careful to avoid pinching fingers between the back of the mounting plate and the wall.

4Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.

C2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for the top support screws and a hole large enough for the power cord to fit through.

Read the instructions on the TOP CABINET TEMPLATE.

Tape it underneath the top cabinet.

Drill the holes, following the instructions on the TOP CABINET TEMPLATE.

CAUTION:Wear safety goggles when drilling holes in the cabinet bottom.

19