GE JVM2052 B4 ADAPT MICROWAVE OVEN BLOWER FOR OUTSIDE BACK EXHAUST (cont.)

Installation Instructions

B4 ADAPT MICROWAVE OVEN BLOWER FOR OUTSIDE BACK EXHAUST (cont.)

3Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.

	BEFORE: Fan Blade	End B
	Openings Facing Up	End B
	Openings Facing Up

End A

4Rotate the unit so that the exhaust ports face

the rear of the cabinet. When you insert the blower unit, the blower wire must be as shown.

Blower unit

Exhaust ports

5Place the blower unit back into the cabinet. Check that the exhaust ports face toward the rear of the cabinet.

Exhaust ports

WARNING:Risk of electric shock can cause injury or death. Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.

NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven.

6Reattach the blower plate to the cabinet so the exhaust ports and blower plate opening are aligned. Attach with 2 blower unit mounting screws and then 3 blower plate mounting screws.

		Blower plate
		mounting screw
Blower unit		(3 screws)
		Blower plate
		Back plate
		Blower unit
		mounting screw
	Blower unit exhaust ports	(2 screws)
	Blower unit exhaust ports

7Attach the exhaust adapter to the rear of the oven by sliding it into the guides at the top center of the back of the oven.

Adapter

Back of

Microwave Oven

Guide

Guide	Locking Tabs

Push in securely until it is in the lower locking tabs. Take care to ensure that the damper hinge is installed so that it is at the top and that the damper swings freely.