Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (on some models)
Safety Instructions
If the refrigerator has an icemaker, it will have to be connected to a cold water line.
Refrigerator Location
A water supply kit (containing copper tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer or from Parts and Accessories,
Do not install the refrigerator where the | Install it on a floor strong enough to support it |
temperature will go below 60°F (16°C) | fully loaded. |
because it will not run often enough to maintain |
|
proper temperatures. |
|
Clearances
Allow the following clearances for ease of | Sides | .1″ (25 mm) |
installation, proper air circulation and | Top | .1″ (25 mm) |
plumbing and electrical connections: | Back | .1″ (25 mm) |
Base Grille
Remove the base grille | To replace the base |
by grasping it at the | grille, align prongs on |
bottom and pulling it | back of grille with slots |
straight out. | in cabinet and push |
| forward until the grille |
| snaps into place. |
Rollers
Instructions Installation Instructions Troubleshooting
The rollers have 3 purposes:
1 Rollers adjust so the door closes easily when opened about halfway. [Front of refrigerator should be 1/4″ (6 mm) higher than the rear of refrigerator.]
2 Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.
3 Rollers allow you to move the refrigerator away from the wall for cleaning.
To adjust the rollers:
Roller Adjustment Screw (3/8″ hex with slot) 
Roller Stabilizing
Brake
Remove the base grille. Turn the roller adjusting screws clockwise to raise the refrigerator, counter- clockwise to lower it. Use a 3/8″ socket wrench or adjustable wrench. Replace the base grille.
Tips
Customer Service
11
