Installation Instructions
STEP 4 INSTALL ANTI-TIP BRACKET
WARNING:
ATTENTION: PRECAUTIONS CONTRE LES BASCULEMENTS
L’appareil ménager est beaucoup plus lourd en haut et il faut le maintenir en place pour éviter la possibilité de son basculement vers l’avant.
•The kit supplied with the unit contains 2 lag bolts and 4 toggles with bolts. The wall bracket will be attached to the wall in 4 places.
•Measure the opening where the unit is to be installed. Mark the center with a vertical line.
•Measure up 81 1/2" from the floor. Mark this point on the wall.
•Using a level, draw a horizontal line on the wall at this height.
•Locate at least 2 studs on the back wall. Mark these points on the horizontal line.
•Place the bottom of the wall bracket with tabs on the horizontal line. Align the center notch on the bracket with the center line on the wall.
•The
•Mark an additional hole at each end of the bracket. If one of the studs is closer to the end of the bracket, mark an additional hole towards the center
of the bracket.
•Drill 1/2" holes into the wall board at the locations marked for the toggles to be mounted (not the stud markings).
•Drill 3/16" holes into wooden studs where marked.
If steel stud construction, drill 1/2" holes into the studs where marked. You will use 2 toggles with the metal studs.
Center | Wall Bracket |
|
Line On Wall
Two Additional
Hole Locations at
Ends of Brackets
Wall Studs
Line on Wall
Center
12