Design Guide
THE INSTALLATION SPACE
DIMENSIONS AND CLEARANCES
The finished cutout width must be
35"
Case Width
Case Depth | * Shipping height. The | |
|
| |
|
| product can be adjusted |
|
| |
|
| to fit into a cutout that |
| *84" From | is |
| max. height. Note that | |
| Floor to | the top case trim |
| Top Frame | |
| at the front is 1/2" higher | |
|
| |
|
| and will overlap upper |
|
| |
|
| cabinetry or soffit. Use |
|
| leveling legs and wheels |
|
| |
|
| for a maximum 1" height |
36" Frame to | adjustment. | |
| ||
Frame Width |
|
Water And Electrical Locations
Electrical and water supply must be located as shown.
The Cutout Depth Must Be 24" Minimum
The unit will project forward, slightly beyond adjacent cabinetry, depending on your installation.
Cutout Depth Beneath a Soffit:
When installed beneathh a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply
is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install
a properly grounded
Note: GFI (ground fault interrupter) is not recommended.
•Water line can enter the opening through the
floor or back wall. The water line should be 1/4" O.D. copper tubing or GE QuickConnect™ kit between the cold water line and water connection location, long enough to extend to the front of the unit. Installation of an easily accessible
Depth Including Handles:
Product Clearances
These units are equipped with a
130° Door Swing | 90° Door Swing |
25" Minimum to Wall
130°
*4" stainless and trimmed models.
5" Pro models.
Allow 25" minimum clearance for a full 130° door swing. Allow 15" for pan removal.
For a 90° door swing, allow 4" minimum clearance to a wall for framed and stainless steel models. Allow 5" minimum clearance for professional models. If the 90° doorstop position is used, pan access
is maintained but pan removal is restricted.
See illustrations pages 5 and 6 to determine door swing interaction with adjacent cabinets or countertops.
3