Installation Instructions
STEP 4 INSTALL ANTI-TIP BRACKET (cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service Kit #WR49X10193. Wall toggles are installed in the drywall and metal studs for stability. Install the wall toggles as follows:
•Drill 1/2" holes at the wall markings made in the holes at the ends of the wall bracket.
•Hold the metal channel flat against the plastic straps and slide the channel through the hole.
Plastic Straps
Metal Channel
•Gently pull back at the ends of the plastic straps to make the channel rest flush behind the wall.
•Hold the ends of the straps in one hand and slide the plastic cap along the straps until the flange of the cap is flush with the wall.
Cap
•Place your thumb between the plastic straps and bend up and down to snap the straps off at the wall.
Install Screws and Bolts:
•Have someone hold the wall bracket centered in place with each of the holes aligned with the correct opening in the bracket and level with the horizontal line.
•Insert the lag screws through the bracket and into the stud. Tighten with a wrench.
Wood Stud
Lag Screw
•Insert the bolts into the toggle by hand until snug. Tighten with a wrench.
Drywall or
Steel Stud
Bolt
Wall Toggle
13
