OVEN CONTROL, CLOCK AND TIMER

Clock

The clock must be set for the automatic oven timing functions to work properly.

The time of day clock cannot be changed during Delay Start. (It can be changed during a regular bake or broil operation.)

To Set the Clock

1.Press CLOCK.

CLOCK

2.Press the number pads the same way you read them. For example, to set 12:34, press the number pads 1, 2, 3 and 4 in that order.

If number pads are not pressed within one minute after you press CLOCK, the display reverts to the original setting. If this happens, press CLOCK and reenter the time of day.

3.Press START. This enters the time and

START

starts the clock.

To check the time of day when the display is showing other information, simply press CLOCK. The time of day shows until another pad is pressed.

Timer

You may program the timer to time cooking or other household activities for up to 9 hours and 59 minutes.

The timer counts down in minutes, 1 minute at a time, until the last 60 seconds are reached, then the control will beep one time. The seconds will not be displayed until the last minute is reached.

When the timer reaches “ :00,” the control will beep 3 times followed by one beep every 6 seconds until KITCHEN TIMER ON/OFF is pressed.

The 6 second tone can be canceled by following the steps in the Special Features of Your Oven Control section under Tones at the End of a Timed Cycle.

How to Set the Timer

KITCHEN 1. Press KITCHEN TIMER ON/OFF.

TIMER

ON/OFF

2.Press the number pads to set the time. For example, to enter 2 hours and 45 minutes, touch 2, 4 and 5 in that order.

If you make a mistake, press

KITCHEN TIMER ON/OFF and begin again.

START

KITCHEN

TIMER

ON/OFF

3.Press START.

After pressing START, “SET” disappears; this tells you the time is counting down, although the display does not change until one minute has passed.

4.When time is up, the oven control signals until you press KITCHEN TIMER ON/OFF. Display then shows the time of day.

NOTE: The minute timer is independent of all the other functions and it does not control the oven. The CLEAR/OFF pad does not affect the timer.

Power Failure

If a flashing time of day is in the display, you have experienced a power failure. Reset the clock. To reset the clock, press CLOCK. Enter the correct time of day by pressing the appropriate number pads. Press START.

(continued next page)

9

Page 9
Image 9
GE Monogram ZET737 manual Oven CONTROL, Clock and Timer