Before you
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions with your Owners Manual for future reference.
WARNING This appliance must be properly grounded. See “Power Supply”, page 8.
ATTENTION Cet appareil doit être correctement mis à la terre. Voir << Alimentation électrique >> à la page 8.
If you have a question concerning the installa- | Proper installation is the responsibility of the |
tion of this product, call the GE Answer | installer. Product failure due to improper |
Center® Consumer Information Service at | installation is not covered under the GE |
800.626.2000, 24 hours a day, 7 days a week. If | Appliance Warranty. See the Owners Manual |
you received a damaged cooktop, you should | for warranty information. |
immediately contact your dealer or builder. |
|
| For Monogram local service in your area, |
| |
| For Monogram service in Canada, |
| |
| For Monogram Parts and Accessories, call |
| |
|
|
FOR YOUR SAFETY
If you smell gas:
1.Open windows.
2.Don’t touch electrical switches.
3.Extinguish any open flame.
4.Immediately call your gas supplier.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
•Installation of this cooktop must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1, latest edition. In Canada, installation must conform with the current
Natural Gas Installation Code, CAN/CGA- B149.1 or the current Propane Installation Code,
•This cooktop has been
•Your cooktop must be electrically grounded in accordance with local codes or, in the absence of local codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition). In Canada, electrical grounding must be in accordance with the current CSA C22.1 Canadian Electrical Code Part 1 and/or local codes.
Contents
Design Information |
|
|
|
Models Available | 3 | Installation |
|
Accessories | 3 | Step 1: Install Downdraft Vent | 9 |
Dimensions and Clearances | 3 | Step 2: Install Ductwork | 10 |
Advance Planning | 4 | Step 3: Install Pressure Regulator | 10 |
Ductwork Advance Planning | 4 | Step 4: Install the Cooktop | 11 |
Tools and Materials Required | 4 | Step 5: Electrical Connections | 12 |
|
| Step 6: Connect Power | 12 |
Cabinetry/Ductwork |
| Step 7: Assemble Burners, Check Ignition | 12 |
Cut the Opening | 5 | Step 8: Install Filters, |
|
Venting Options | 6 | Check Operation of Downdraft | 13 |
Ductwork Fittings | 7 |
| 14 |
Power Supply Locations | 8 | JXRB57 Kit, Indoor Remote Blower Location | |
|
| JXBC57 Kit, Outdoor Remote Blower Location | 17 |
2
