General Information
Press the “ENTER” button.
Press the “ENTER” button.
The above two pages are typical of communications diagnostics, one page for each port. The LCD display will show four lines of information about the port:
LINE 1: Will show the type of port protocol that has been selected. It will also show the Modbus address (if appropriate) and whether the port is
LINE 2: Will show the settings for the port such as baud rate, bits per character, stop bits, and parity.
LINE 3: Shows a live update of counts of messages transmitted, received, and errors.
LINE 4: Shows a mimic of LED’s for TX, RX, and ERR. For example, the TX LED lit (T*) means the H- 100 Control Panel is transmitting. Not lit
Press the button.
Press the “ENTER” button.
This is a typical first Internal Exercise and HTS page.
LINE 1: Indicates if internal exercise is enabled. This field is editable.
LINE 2: Day of week and time of day to start the exercise weekly. These fields are editable.
LINE 3: How much time remains before exercise is completed. It starts with 20 minutes.
LINE 4: The “More” field to allow page selection.
Press the “ENTER” button.
EXERCISE/HTS
There are four pages under this menu item – two for internal exercise and two for HTS. This is where the internal exercise can be setup and enabled (see the Exercise Setup Using Front Panel section) and the HTSs can be enabled and monitored.
Do the following to view the internal exercise and HTS pages:
Press the “MENU” button.
This is a typical second Internal Exercise and HTS page.
LINE 1: Indicates if QuietTest® is enabled. This field is editable.
LINE 2: Can be used to start a 20 minute exercise period right now. This field is editable.
LINE 3: Indicates if the HTS switches should be exercised during normal exercise mode. This field is editable.
LINE 4: The “More” field to allow page selection.
Press the “ENTER” button.
21
