Generac Power Systems H-100 technical manual Set Date And Time, ‹Date And Time Setup Using Genlink

General Information

H-100 Control Panel Technical Manual

Use the up and down arrow key until a “Y” appears.

Press the “ENTER” button to exit edit mode.

Setup of Normal Exercise with transfer to load dur- ing exercise is now complete. For this example, exer- cise will start every Wednesday at 10:30 AM and run until about 10:50 AM. However, the HTS settings may change this time.

While normal exercise is running, the “Time Remaining” will display the approximate number of minutes left before exercise is completed.

SET DATE AND TIME

‹DATE AND TIME SETUP USING GENLINK

Connect to the H-100 control panel.

The date and time field is displayed in the lower left corner of the screen.

Using the mouse cursor, click on the date and time field.

Any of the fields are editable. Note that hours are entered as 0 – 23. If the PC being used has reliable date and time settings, pressing the “Synchronize with PC!” button will copy the PC date and time into the H-100 Control Panel. Otherwise, press “Apply” after making changes. The date and time on the GenLink screen may take a few seconds to update.

‹DATE AND TIME SETUP USING FRONT PANEL

Press the “MENU” button.

The H-100 Control Panel contains a real time clock to keep track of date and time. This is used to schedule internal exercise, time stamp alarm/event log entries, and time stamp reports. The date and time can be changed using either GenLink or the front panel display.

33