Genie 114002 manual Loading for Transport, Transport Instructions

Third Edition • First Printing Operator’s Manual

Loading for Transport

1Fully lower the platform.

2Push in the red Emergency Stop buttons, turn the key switch to the off position and remove the key.

3Remove the outriggers from the base and place them in the storage sockets.

4DC models: Disconnect the battery cable and remove the battery pack.

5Inspect the entire machine for loose or unsecured items.

6Slide the stop bracket to the top lock position.

a

b

astop bracket

bloading pivot

All models without tilt-back frame

a

b

astop bracket

bloading pivot

All models with tilt-back frame

7 Hook the loading pivot to the stop bracket.

TRANSPORT INSTRUCTIONS

8Position the machine flush against the loading surface. Lower and lock the stop bracket to the lowest lock pin position above the loading surface.

9All models with tilt-back frame:

Be sure both stop bracket lock pins are fully locked.

Be sure both tilt-back frame swivel casters are locked.

10 Slide out the T-handle until the lock pin snaps into place.

11 Lift the T-handle to tilt the machine

onto the loading surface. Use the appropriate number of people and proper lifting techniques.

12Carefully push the machine into the transport position.

13Return the sliding T-handle to the stowed position.

14Secure the machine base and mast to the transport vehicle. See Securing the Machine on the next page.

15Reverse this procedure to unload the machine.

Part No. 114002 Genie AWP Super Series 23