3 Required Programming
NOTE: Before you begin programming, check to make sure there are no objects in the garage door opening.
INTRODUCTION
Now that your Genie garage door opener is installed, you will want to program the opener so that the door opens and closes properly and all remote devices operate correctly. The following steps guide you through setting your opener so it functions properly for you.
The following information will take you through programming your opener’s functional settings for use.
There are only 2 “required” programming processes you will need to follow to set up your garage door opener for operation:
1.“TRAVEL LIMITS”
2.“REMOTE PROGRAMMING”
Term Definitions:
Travel Limits programming allows you to set how far your door travels up or down in opening and closing your garage door.
Remote Programming synchronizes your remote control devices (remotes, wall console, and keypad) with the powerhead.
Force Control refers to how much power is needed to move (open/ close) your particular door and does NOT require programming.
Speed Control refers to how fast or slow your opener opens and closes your particular door and is preset at the factory. This function does NOT require programming.
Overview of PoWERHEAD Controls
This section describes the programming functions on the powerhead of the opener. Use the following information to familiarize yourself with the buttons, LED indicators and products used to program functions.
Powerhead: There are 3 programming buttons and 2 LED lights on the powerhead. Each of the buttons is used to enter and complete the setup programming. The LED lights indicate status or a function change by illuminating ON, OFF, or ON FLASHING in one of three different colors: blue, red or purple.
There are 4 programs (The 2 “Factory Set” programs are unlikely to need changes.)
1.Door Travel Limits Program
–This program is used to set how far your door travels up and down.
2.Remote Programs (Default menu)
–These show you how to program your remotes to synch with additional remote control devices, wall consoles, keypads, and the powerhead.
3.Door Force Program (Factory Set)
–This program is only used for minor adjustments under certain circumstances.
4.Door Speed Program (Factory Set)
–This program does not require manually initiated changes.
NOTE: The 3 programming buttons are for programming ONLY. These buttons should NOT be used to operate the opener once the Required Programming section has been successfully completed.
ROUND LED | Close Travel | Open Travel |
Indicator | Button |
PROGRAM
SET – +
LONG LED
Indicator
Located on bottom of Powerhead.
PROGRAM
| Enters into and selects programming menus. |
| SET |
| |
– | + and advance through menus |
| 5 |
7/13/12 10 17 AM |
