4 Optional Programming
Clearing Memory FOR RemoTES
1 Press the Program Set button on the Powerhead and hold 2 seconds, round LED comes ON.
PROGRAM |
|
| PROGRAM |
T | – | + | SET |
HOLD |
|
|
|
2 seconds |
|
|
|
2 Release the Program Set button, round LED goes off and the long LED flashes purple.
PROGRAM
– +
3 Press up arrow button (+) and down arrow button
PROGRAM | PROGRAM |
SET | SET |
HOLD | HOLD |
|
|
|
|
|
|
4 | To verify that the memory is cleared, press |
|
|
| |
| a remote button that was previously |
|
|
| |
| programmed to the Powerhead. |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
If the memory has been cleared, the Remote will not activate the door opener.
NOTE: The garage door opener will operate normally using the Wall Console.
NOTE: When the remote is pressed the round LED will flash blue but will not activate the door opener.
NOTE: Clearing Remotes from the Powerhead memory will clear ALL programmed Remotes and wireless Keypads. Your opener will no longer recognize any signal received from a missing Remote.
All remaining (or recovered) Remotes and wireless Keypads MUST BE reprogrammed as shown on pages 9 and 12.
(continued next page) 13
7/13/12 10 17 AM |