4 Optional Programming
PROGAMMING THE WIRELESS KEYPAD
Setting Up a PIN
1.Press in order
2.Press the Program key .
3.Enter your new PIN
4.Press Program key .
Your keypad is ready for programming.
Programming
Locate Your Opener’s Programming Buttons and LED
Synchronizing Keypad to Opener
PROGRAM |
| PROGRAM |
|
| PROGRAM |
|
|
– | + | SET | – | + | SET | – | + |
HOLD 2 seconds |
|
|
|
|
|
|
|
1.Press and hold Program Set key for 2 seconds. (The round LED turns blue and then goes o. The long LED will begin ashing purple
4.Press Up/Down key again. Opener LEDs will turn o.
5.Press Up/Down key again. Door opener will run.
NOTE: Pressing any key will stop or start the opener while the door is in motion. The door will automatically stop fully open or closed. When the door has stopped moving, pressing on any single button will activate door until backlight goes off (30 seconds)
NOTE: Rapid blinking of the red LED on the Powerhead indicates an error. When the blinking stops, you must start programming steps over.
Resetting PIN
If you have forgotten your PIN or you fear it may have fallen into unauthorized hands, you must erase the old programming.
To erase, follow these simple steps:
HOLDHOLD
1.Press and hold Program key and then the Up/Down key for
5 seconds or until the LED starts to slowly blink. When blinking stops you have successfully erased the old programming.
2.Go back and follow the steps in “Setting Up a Pin”and“Programming”.
Changing Your PIN
Opener
2.Enter your PIN.
3.Press Up/Down key . Opener LEDs will stay on steady.
Note: For multiple doors, see the full instructions packed with the keypad.
12
1.Enter your current PIN, then press Program key .
2.Enter your new PIN, press Program key .
Note: If you are still having trouble with the keypad, refer to the full instructions packed with the keypad.
7/13/12 10 17 AM |