3 Required Programming
18 Press and release the same button on the remote (both LED’s flash blue and then turn off).
PROGRAM |
| PROGRAM |
|
SET | – | SET | – |
The Remote button is now programmed.
Repeat as necessary for additional Remotes.
To program the same Remote for other garage door openers, repeat the steps above using one of the other two Remote buttons.
Each Remote can be programmed for three door openers.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS READY TO USE!
NOTE: For Car2U and HomeLink, park the car outside the garage with the ignition key in the “Accessory” position. Follow the Car2U or HomeLink instruction to set the button in the car to Genie mode.
IMPORTANT: Your HomeLink® device will ONLY respond to pressing THIS button
on your Intellicode remote when it's searching to connect to your remote in "Learn Mode" as described in the HomeLink® instruction manual.
19
Press and release the same button on the remote (the door should open or close).
| 11 |
7/13/12 10 17 AM |
