Genie TRILOG 1200/1500 Adjustment Guides continued, Locating Safe-T-Beam Pairs, One Door Garage

6 Maintenance and Adjustments

Adjustment Guides (continued)	LED indicator colors:	OFF	Blue	Purple	Red
Speed Settings (DC motors only)
Speed settings are pre-programmed at the factory for the maximum
speed. Speed settings should not need adjustment with this unit.
However, travel speed for the opener can be adjusted to a slower
speed in both the Open and Close directions, to minimize wear on
heavier sectional doors.
NoTE: One-piece doors are automatically set to the slowest speed	Note: PowerLift® 900, GPower™ 900 openers DO NOT have speed
during Limits programming and cannot be adjusted.	adjustments.
There are 3-speed settings available for sectional doors. Please note	Locating Safe-T-Beam Pairs:
that speed may be affected by door weight and balance, along with	Source (Red LED) and Sensor (Green LED)
condition of door components and tracks.

Sun

Speed Adjustment

	Action		LED Indication/Result
1	Press and hold for	PROGRAM
	about 10 seconds
	or until both LEDs	SET		BLUE BLUE
	turn BLUE.
	Then release.
2	Press twice.
				BLUE BLUE
3	Press and	PROGRAM
	release.		OFF	Flashes BLUE 3 Times

Red	Green
LED	LED

One Door

Garage

Green	Red
LED	LED

Three Door

Garage

Green	Red	Red	Green
LED	LED	LED	LED

Two Door

Garage

Red	Green	Green	Red
LED	LED	LED	LED

					SET	Then the Current Speed setting
						for OPENING travel will display.
						SEE CHART IN NEXT COLUMN.
4	Press either until					NOTE: Depending on the criteria
	you reach the					mentioned above, you may not
	desired setting.					have the option to increase speed.
5	Press and		PROGRAM			LOCKS IN OPENING SETTING.
	release.					Flashes BLUE
				SET			OFF
						3 Times
						Then the Current Speed setting
						for CLOSING travel will display.
						SEE CHART IN NEXT COLUMN.
6	Press either until					NOTE: Depending on the criteria
	you reach the					mentioned above, you may not
	desired setting.					have the option to increase speed.
7	Press and		PROGRAM			LOCKS IN CLOSING SETTING.
	release.						FLASH BLUE
	Both LEDs FLASH			SET		FLASH BLUE
	BLUE to confirm setting.
		SPEED SETTINGS DONE

Single Garage Door

•Determine which side of the garage receives direct sunlight.

•Position the Source (Red LED) on the direct sunlight side

Multiple Garage Doors

•NEVER position Safe-T-Beam modules where signals will cross.

•Place the Source (Red LED) Safe-T-Beams on adjacent doors facing in opposite directions.

NOTE: Direct sunlight creates interference with Safe-T-Beam Sensor (Green LED). Sensor modules CAN be positioned further away from door opening if necessary to avoid sunlight but no further off the wall to maintain alignment with paired Source module.

Sun

Red	Green
LED	LED

One Door

Garage

19

G999-393 Manual-ScrewBeltChain-EN indd 19 7/13/12 10 17 AM